LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2016 >> ProMaster City SLT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Fan, Cooling >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

Fig 1: Radiator Mounts & Retainers
GC0172047Courtesy of CHRYSLER GROUP, LLC
NOTE:

Right side shown in illustration, left side similar.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Install the radiator fan shroud from the bottom of the vehicle.
  3. Place the radiator fan shroud into the radiator mounts (2) and engage the retainers (1).
    Fig 2: Cooling Fan Connectors & Retainers
    GC0171732Courtesy of CHRYSLER GROUP, LLC
  4. Remove the support and lower the vehicle.
  5. Engage the transmission oil cooler line retainer (1) to the radiator fan shroud.
  6. Connect and lock the radiator cooling fan harness connector (4).
  7. Connect and lock the radiator cooling fan speed control module harness connector (3).
  8. Engage the wire harness retainer (2) to the fan shroud.
    Fig 3: Coolant Reservoir, Bolts & Hoses
    GC0171597Courtesy of CHRYSLER GROUP, LLC
  9. Position the pressurized coolant bottle (1) onto the rubber grommet.
  10. Install the two bolts (2) and tighten to the proper specification. Refer to SPECIFICATIONS .
    Fig 4: Front Bumper Reinforcement & Frame Rail Bolts
    GC0171187Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Left side shown in illustration, right side similar.

  11. Position the core support (4), while aligning the radiator to the bushings (1) and install the two lower bolts (3) hand tight.
    Fig 5: Bolts & Nut
    GC0171854Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Left side shown in illustration, right side similar.

  12. Install the bolts (1) to hold the front of the right and left load beams to the radiator support panel and tighten the bolts to the proper specification. Refer to SPECIFICATIONS .
  13. Tighten the two previously installed lower radiator core support bolts to the proper specification.
    Fig 6: Right Lower Splash Shield, Bolts & Screw
    GC0171975Courtesy of CHRYSLER GROUP, LLC
  14. Install the right lower splash shield (1) with four bolts (3 and 4) and screw (2).
  15. Install the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
  16. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals