Sensor, Coolant Temperature: Removal: 3.6L
WARNING: This page is about a different car, the 2014 RAM ProMaster 3500, 2014 RAM ProMaster 2500, and 2014 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
The Engine Coolant Temperature (ECT) sensor on the 3.6L engine is installed into a water jacket at rear of the cylinder head on the left side of the engine.
WARNING:
Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the coolant temperature sensor.
NOTE:
Do not waste reusable coolant. If solution is clean, drain coolant into a clean container for reuse.
- Raise the vehicle.
- If equipped, remove the belly pan.
- Partially drain the cooling system. Refer to STANDARD PROCEDURE .
- Disconnect the electrical connector from the sensor.
- Remove the sensor from the cylinder head.