LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2016 >> Dart SE, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Sensor, Coolant Temperature >> Removal >> Removal

Sensor, Coolant Temperature: Removal: Removal

WARNING:

Do not remove cylinder block drain plugs, pressure caps, or loosen radiator draincock with system hot and under pressure. Serious burns from coolant can occur.

Fig 1: Positive Cable Terminal, Negative Cable Terminal, Fastener & Battery
GC0152380Courtesy of CHRYSLER GROUP, LLC
  1. Drain the cooling system.
  2. Disconnect the positive (1) and negative (2) battery cable.
  3. Remove the nut (3) for the battery hold down clamp and remove battery.
  4. Remove the engine cover.
  5. Remove the air intake assembly.
    Fig 2: Engine Coolant Temperature Sensor
    GC0152369Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the engine coolant temperature sensor harness connector.
  7. Remove the temperature sensor (4) from the thermostat housing.
scientia non olet · About LEMON Manuals