Coil, Ignition: Installation: 6.2L

CAUTION:

Do not apply a silicone based grease such as Mopar® Dielectric Grease to the ignition coil rubber boot. The silicone based grease will absorb into the boot causing it to stick and tear.

Place a small, 360° bead of Uniflor 8172 lubricant (1) along the inside opening of the coil boot approximately 1 to 2 mm from the chamfer edge but not on the chamfered surface.

Fig 1: Ignition Coil Wire Harness Connector & Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the ignition coil into cylinder head and push both spark plug boots onto each spark plug.
Install the two coil mounting bolts (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
Connect the ignition coil wire harness connector (2) to the coil and lock the connector.

Fig 2: Engine Covers
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover(s) (1).
Connect the negative battery cable.