Section 133 (Steering System): Pump: Installation: 3.6L

WARNING: This page is about a different car, the 2014 RAM ProMaster 3500, 2014 RAM ProMaster 2500, and 2014 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before installing power steering pressure hose on power steering pump, replace O-ring on end of power steering pressure hose. Lubricate O-ring using clean power steering fluid.

Fig 1: Identifying Power Steering Pump, Pressure Hose Fitting, Mounting Bolts & Spacers

Courtesy of CHRYSLER GROUP, LLC

Install power steering pump (2) onto its mounting bracket (5).
Install the three power steering pump mounting bolts and spacers. Tighten pump mounting bolts to 25 N.m (18 ft. lbs.).

Fig 2: Identifying Power Steering Pump, Pressure Hose Fitting, Supply Hose & Pulley Bolts
Courtesy of CHRYSLER GROUP, LLC
Install power steering pump pressure fitting (4) and tighten to 46 N.m (34 ft. lbs.).
Slide fluid supply hose onto pump (3) fitting and install clamp securing it in place.
Install the power steering pump pulley. Refer to PULLEY, POWER STEERING PUMP, INSTALLATION .
Lower vehicle.
Connect negative (-) battery cable on negative battery post.
Fill and bleed power steering system. Refer to STANDARD PROCEDURE .
Inspect for leaks.