LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2014 >> Viper Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Active Damping Control >> Installation >> Installation

Module, Active Damping Control: Installation: Installation

Fig 1: Active Damping Control Module, Wire Harness Connectors & Screws
GC0156609Courtesy of CHRYSLER GROUP, LLC
  1. Place the Active Damping Control Module (ADCM) (1) into position on the mounting bracket.
  2. Install and securely tighten the retaining screws (3).
  3. Connect the wire harness (2) connectors to the ADCM (1).
  4. Connect the negative battery cable.
  5. Install the trunk floor pan cover.
  6. Perform the ADCM Verification Test. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals