LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2014 >> Dart GT, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System >> Column >> Installation >> Installation

Steering System: Column: Installation: Installation

Fig 1: Plastic Bracket & Screws
GC0155726Courtesy of CHRYSLER GROUP, LLC
  1. If the column was replaced, position the plastic bracket (1) and install and securely tighten the screws (2).
    Fig 2: Steering Column Mounting Bolts & Nuts
    GC0155769Courtesy of CHRYSLER GROUP, LLC
  2. Install the steering column through the steering column opening.
  3. Raise the column onto the mounting studs and install the two mounting nuts (2) on the studs and install the mounting bolts (1).
    NOTE:

    Verify that the tilt lever is in the unlocked position prior to tightening the steering column fasteners.

  4. Install two column mounting bolts (1). Tighten all 4 column fasteners to 15 N.m (180 in. lbs.)
    Fig 3: Lower Coupling Bolt
    GC0084367Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    A new pinch bolt (3) must be installed every time the pinch bolt is removed.

  5. Verify the front wheels of vehicle are in the STRAIGHT-AHEAD position.
  6. Slide the intermediate shaft (2) onto the steering gear pinion shaft (4).
  7. Install a NEW  pinch bolt (3) and tighten the bolt to 30 N.m (22 ft. lbs.).
  8. Install knee blocker, if equipped.
  10. Confirm that:
    1. The front wheels are in the STRAIGHT-AHEAD position.
    2. The turn signal stalk is in the NEUTRAL position.
  12. Connect wiring harness connectors at the Steering Column Control Module (SCCM).
  13. Install the driver airbag. Refer to AIR BAG, DRIVER, INSTALLATION .
    Fig 4: Upper Shroud
    GC0156068Courtesy of CHRYSLER GROUP, LLC
  14. Install the upper column shroud (1) over the column assembly.
    Fig 5: Lower Shroud & Screws
    GC0155636Courtesy of CHRYSLER GROUP, LLC
  15. Install the lower shroud (1). Refer to SHROUD, STEERING COLUMN, LOWER, INSTALLATION  and SHROUD, STEERING COLUMN, UPPER, INSTALLATION .
    WARNING:

    Do not connect the battery ground cable without following the proper procedure as indicated in the following step. Personal injury or death may result if the Airbag System Test is not performed first.

  16. Reconnect the battery ground terminal following the Airbag System Test found in Restraints. Refer to DIAGNOSIS AND TESTING .
  17. Perform Vehicle Trim Procedure. Refer to STANDARD PROCEDURE .
  18. Test the operation of all column mounted components. If applicable, reset the radio and the clock as necessary.
  19. Road test the vehicle to ensure proper operation of the steering system.
scientia non olet · About LEMON Manuals