LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2014 >> Charger SRT-8 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Front Axle) >> Installation >> Installation

Section 3 (Front Axle): Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Removing/Installing Front Axle
GC0081412Courtesy of CHRYSLER GROUP, LLC
  1. Install front axle assembly (1) into position. Install and tighten axle housing-to-engine bolts to 65 N.m (48 ft. lbs.).
    Fig 2: Power Steering Return Line & Clips
    GC0080564Courtesy of CHRYSLER GROUP, LLC
  2. Install power steering return line to cradle by fastening clips (1).
    Fig 3: Front Axle Housing Support Bracket
    GC0081411Courtesy of CHRYSLER GROUP, LLC
  3. Install axle assembly support bracket (1) and torque bolts to 28 N.m (21 ft. lbs.).
  4. Install RH catalytic converter/exhaust pipe assembly. Refer to CONVERTER, CATALYTIC, INSTALLATION .
  5. Install front propeller shaft. Refer to INSTALLATION .
  6. Install intermediate shaft. Refer to INSTALLATION .
  7. Install both front halfshafts. Refer to INSTALLATION .
    Fig 4: Fluid Fill Plug Location
    GC0081451Courtesy of CHRYSLER GROUP, LLC
  8. Fill axle with 600 ml (0.64 qts.) of Mopar® 75W-90 Synthetic Gear Lubricant. Fluid level should be at or near bottom of fill hole. Torque fill plug (1) to 30 N.m (22 ft. lbs.).
  9. Lower vehicle.
scientia non olet · About LEMON Manuals