LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2013 >> Viper Base >> Repair and Diagnosis >> Engine Performance >> Ignition System (Service Information) >> Cable, Ignition >> Removal >> Removal

Cable, Ignition: Removal: Removal

Fig 1: View Of Spark Plug Wires
GC0135285Courtesy of CHRYSLER GROUP, LLC
NOTE:

Use the following procedure when removing the high tension cable from the spark plug. Grasp the ignition cable boot as close as possible to the spark plug. Rotate the cable boot 1/2 turn slightly and pull straight away from the spark plug in a steady motion. For the coil side grasp as close to the end of the cable boot and pull away in the same fashion.

  1. Disconnect and isolate negative battery cable at battery.
  2. Remove ignition cables from coils.
  3. Remove ignition cables from spark plugs.
scientia non olet · About LEMON Manuals