LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2013 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 584 (Engine Cooling System) >> Engine >> Pump, Water >> Inspection >> 5.7L/6.4L

Pump, Water: Inspection: 5.7L/6.4L

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 5.7L .
  3. Remove the resonator mounting bracket.
  4. Remove cooling fan assembly. Refer to FAN, COOLING, REMOVAL .
  5. Drain cooling system. Refer to STANDARD PROCEDURE .
    Fig 1: Coolant Temperature (ECT) Sensor Electrical Connector, Heater Tube & Retaining Bolt
    GC0144611Courtesy of CHRYSLER GROUP, LLC
  6. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
  7. Remove bolt (1) and the heater tube (3) from the water pump.
  8. Disconnect the Engine Coolant Temperature (ECT) sensor wire harness connector (2).
    Fig 2: Thermostat Housing, Water Pump, Belt Tensioner, & Idler Pulley
    GC0137090Courtesy of CHRYSLER GROUP, LLC
  9. Remove the upper radiator hose from the thermostat housing (1) and position aside.
  10. Remove bolt and the idler pulley (5).
  11. Remove belt tensioner assembly (4). Refer to TENSIONER, BELT, REMOVAL .
  12. Remove the lower radiator hose from the water pump and position aside.
  13. Remove the upper stud bolt (2).
  14. Remove the water pump mounting bolts (6) and carefully remove pump (3) from the cover while removing the metal bypass tube.
scientia non olet · About LEMON Manuals