Stabilizer Bar, Front: Installation: Installation

Fig 1: Link Ball Joint AT Stabilizer Bar

Courtesy of CHRYSLER GROUP, LLC

NOTE:

When attaching stabilizer link to stabilizer bar, make sure link ball joint stem is pointed inboard toward engine cradle.

On each side of vehicle, raise stabilizer bar (4) to stabilizer link (3) and slide link ball joint stem (1) through mounting hole in bar. Loosely install nut (5) at this time.

Fig 2: Front Stabilizer Bar Bushing On Bar
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Because of stabilizer isolator outer shape, it is very important to install isolators in position discussed in following step.
Utilizing slit in isolator, install each stabilizer bar isolator (1) on bar resting against locating collar (2) as shown in illustration. Make sure slit in isolator is positioned toward rear of vehicle.

Fig 3: Front Stabilizer Bar Bushing Retainer
Courtesy of CHRYSLER GROUP, LLC
On each side of vehicle, install stabilizer bar isolator retainer halves (1),(2) around isolator (3).

Fig 4: Front Stabilizer Bar Bushing Retainer Bolts
Courtesy of CHRYSLER GROUP, LLC
On each side of vehicle, install bolts (2) securing stabilizer bar isolator retainer halves (1) to cradle. Tighten bolts to 60 N.m (44 ft. lbs.).

Fig 5: Front Stabilizer Bar Heat Shield
Courtesy of CHRYSLER GROUP, LLC
On each side of vehicle, install stabilizer bar heat shield (3) over stabilizer bar isolator retainer. Install mounting screws (1).

Fig 6: Link Ball Joint AT Stabilizer Bar
Courtesy of CHRYSLER GROUP, LLC
While holding stem from rotating at hex (1) or flat (2) tighten stabilizer link nuts at each end of stabilizer bar (4) to 128 N.m (95 ft. lbs.).
Install belly pan. Refer to BELLY PAN, INSTALLATION .
Lower vehicle.