LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2012 >> Avenger SXT Plus >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Pump >> Removal >> 3.6L Engine

3.6L Engine

Fig 1: Shield Mounting Bolts & Heat Shield
GC0147042Courtesy of CHRYSLER GROUP, LLC
  1. Remove negative (-) battery cable from battery and isolate cable.
  2. Remove cap from power steering fluid reservoir.
  3. Using a siphon pump, remove as much power steering fluid as possible from power steering fluid reservoir.
  4. Remove accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  5. Raise and support vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove 3 heat shield mounting bolts (2). Remove heat shield (1) from vehicle.
    Fig 2: Supply Hose Clamp
    GC0147044Courtesy of CHRYSLER GROUP, LLC
  7. Remove supply hose clamp (1) and remove supply hose from power steering pump fitting.
    Fig 3: Hose Fitting & Pump
    GC0147043Courtesy of CHRYSLER GROUP, LLC
  8. Remove power steering pump pressure hose fitting (2).
  9. Remove three pump mounting bolts through pump pulley (not shown in illustration).
  10. Remove pump (1) (with pulley) from below.
  11. If pulley needs removal, refer to PULLEY, POWER STEERING PUMP, REMOVAL .
scientia non olet · About LEMON Manuals