Intermittent Condition, Pre-Diagnostic Troubleshooting Procedure, Pcm/TCM Programming & Powertrain Verification Test

• Standard Procedure
  • Intermittent Condition
    • Diagnostic Test
  • Pre-Diagnostic Troubleshooting Procedure
    • Diagnostic Test
  • Pcm / TCM Programming
    • Pcm / TCM Flash PROGRAMING
    • Table Of Contents
    • Section 1 - Pcm / TCM Flash Procedure
    • Repair Procedure - Using STARSCAN® Or STARMOBILE® Desktop Client
    • Repair Procedure - WITECH™ Diagnostic Application
    • Section 2 - Additional Pcm / TCM Replacement Procedures
      • Notes
      • If an EDC16-U31 PCM/ECM (2.0L) was replaced, perform the following additional steps and/or routines:
      • If an EDC16-C2 PCM/ECM (2.2L) was replaced, perform the following additional steps and/or routines:
      • If an EDC16-CP31 (3.0L) was replaced, perform the following additional steps and/or routines:
      • If an EDC16-CP31-2 (2.8L) was replaced, perform the following additional steps and/or routines:
      • If a CM849 PCM/ECM (5.9L) was replaced, perform the following additional steps and/or routines:
      • If a CM2100 PCM/ECM (6.7L) was replaced, perform the following additional steps and/or routines:
      • TCM Replacement
      • If an EGS TCM was replaced, perform the following additional steps and/or routines:
    • Step-By-Step Instructions
    • Section 3 - Authorized Modification Label
    • Required Tools/Equipment:
    • Tech Tips And Information:
    • Parts Required
  • Powertrain Verification Test
    • Notes
    • Diagnostic Test