Charging System (Service Information): Generator: Installation: 3.6L

Fig 1: Electrical Connector, Generator & Two Upper Mounting Bolts

Courtesy of CHRYSLER LLC

1. Position the generator (1) onto the engine mounting bracket.
2. Install the lower mounting bolt and the two uppper mounting bolts (3) to generator (1). Tighten bolts to 42 N.m (31 ft. lbs.).
3. Connect the field wire connector (3) to the generator.
4. Install B+ terminal and nut to generator mounting stud. Tighten nut to 10 N.m (88.5 in. lbs.)
5. Snap the plastic protective cover over the B+ terminal.
6. Raise and support the vehicle.
   Fig 2: Belt Tensioner, Accessory Drive Belt

   Courtesy of CHRYSLER LLC
7. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
8. Install the inner splash shield.
9. Install the right front wheel.
10. Lower the vehicle.
11. Connect negative battery cable, tighten nut to 4.5 N.m (40 in. lbs.).
12. Start the engine and verify the generator is functioning properly.