Receiver, Keyless Ignition Node: Removal: Removal

Fig 1: Bezel Assembly

Courtesy of CHRYSLER LLC

1. Disconnect the negative battery cable.
2. Remove the switch-bank and bezel assembly (1). Refer to POD, SWITCH BANK, REMOVAL .
   Fig 2: Instrument Panel Center Bezel

   Courtesy of CHRYSLER LLC
3. Remove the instrument panel center bezel (1). Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
   Fig 3: Wire Connector, Clips & KIN

   Courtesy of CHRYSLER LLC
4. Disconnect the wire connector (1) from the Keyless Ignition Node (KIN).
5. Push down on the release clips (2) (two on top and one on the bottom) and push the KIN (3) out the front of the instrument panel.