Flash: HVAC Control Module (24-004-11)

WARNING: This page is about the Durango Citadel, 3.6 G, AWD, which is a different variant/trim than selected.

Publication date: 2011-02-25
Reference number: 24-004-11

FLASH: HVAC CONTROL MODULE

TECHNICAL SERVICE BULLETIN

Reference Number(s): 24-004-11, Date of Issue: February 25, 2011

CHRYSLER:	2011 (WD) Durango; 2011 (WK) Grand Cherokee
GROUP:	Heating & Air Conditioning

NOTE: HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS AVAILABLE BY SELECTING "HELP" THEN "HELP CONTENTS" AT THE TOP OF THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
THE wiTECH SOFTWARE LEVEL MUST BE AT RELEASE 11.03 OR HIGHER TO PERFORM THIS PROCEDURE.

SUBJECT

Flash: HVAC Control Module

OVERVIEW

This bulletin involves selectively erasing and reprogramming the HVAC Module with new software.

NOTE: This bulletin applies to vehicles equipped with a 3.6L and 5.7L engines (sales code ERB or EZH) and Air Conditioning with duel zone control (sales code HAF) and WD models also equipped with Rear Air Conditioning W/Heater (sales code HBB) built before January 6, 2011 (MDH 0106XX).

MODELS

2011 (WD) Durango

2011 (WK) Grand Cherokee

SYMPTOM/CONDITION

The customer may experience any of the following conditions:

A increase or decrease of blower speed when the vehicle is accelerated and/or when the vehicle is in a turn (WK/WD 3.6L vehicles only).
HVAC front controls may switch to display rear controls without actually changing any settings to the rear or front controls (WD vehicles only with Rear Air Conditioning W/Heater sales code HBB).
In Automatic Temp Control mode with high fan setting, a howl/moan and/or rumble sound (higher pitch) may be heard in cold temperatures <=15°F (<=9.5°C).
Slight popping or ticking sound when switched into or out of Recirculation Mode in cold temperatures - 22°F (- 30°C).

Updating the ATC software will correct these condition.

DIAGNOSIS

Using a Scan Tool (wiTECH™) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all HVAC systems are functioning as designed. If DTC's are present record them on the repair order and repair as necessary before proceeding further with this bulletin.

If the above condition is present, perform the Repair Procedure.

REPAIR PROCEDURE

NOTE: If this flash process is interrupted/aborted, the flash should be restarted.

Using the wiTECH Diagnostic Application for flashing a HVAC is made available through the wiTECH Diagnostic Application. For instructions select the "HELP" tab on upper portion of the wiTECH window, then "HELP CONTENTS." This will open the Welcome to wiTECH Help screen were help topics can be selected.
1. Clear any DTC's that may have been set in other modules due to reprogramming. The wiTECH application will automatically present all DTCs after the flash and allow the tech to clear them.

POLICY

Reimbursable within the provisions of the warranty.

TIME ALLOWANCE

Labor Operation No:	Description	Amount
18-19-62-90	Module, Automatic Temperature Control (ATC) - Reprogram (C)	0.2 Hrs.

FAILURE CODE

FM	Flash Module