Gas Engine

Fig 1: Removing/Installing Power Steering Pump Mounting Bolts Through Pulley Openings

Courtesy of CHRYSLER LLC

Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with new. Lubricate the O-ring with clean power steering fluid.
Place the pump in mounting position. Install the three bolts (1) through the pulley (3) openings. Tighten the mounting bolts (1) to 26 N.m (19 ft. lbs.).
Install the drive belt (2). Refer to Cooling/Accessory Drive/BELT, Serpentine - Installation .

Fig 2: Removing/Installing Supply Hose At Power Steering Pump
Courtesy of CHRYSLER LLC
Install the supply hose (1) at the pump (3).
Clamp the hose clamp (2) securing the supply hose (1) to the pump.

Fig 3: Removing/Installing Tube Nut At Power Steering Pressure Hose
Courtesy of CHRYSLER LLC
If equipped with a non-turbo engine:
1. Install the pressure hose (3) at the pump pressure port (5). Tighten the tube nut to 32 N.m (24 ft. lbs.).
2. Install the pressure hose routing bracket bolt (2) to the upper mount (8).
Fig 4: Removing/Installing Pressure Hose At Pump Pressure Port - Turbo Gas Engine
Courtesy of CHRYSLER LLC
If equipped with a turbo engine, install the pressure hose (3) at the pump (2) pressure port. Tighten the tube nut (1) to 32 N.m (24 ft. lbs.).
Fill and bleed the power steering system. See Steering - Standard Procedure .
Check for leaks.
Install the engine appearance cover.