LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2009 >> Caliber R/T, EDG >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Column >> Assembly >> Assembly >> Ignition Switch

Ignition Switch

Fig 1: Identifying Ignition Switch & Retaining Tabs
GC0083177Courtesy of CHRYSLER LLC
  1. Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
    CAUTION: Use care when installing the ignition switch on the lock cylinder housing to avoid damaging the key-in plunger (3).
  2. Align the ignition switch with the key-in plunger (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the switch, snapping it into place over the retaining tabs.
    Fig 2: Removing/Installing Ignition Switch
    GC0083176Courtesy of CHRYSLER LLC
  3. Install the ignition switch (2) mounting screw (1). Tighten the screw to 2 N.m (18 in. lbs.).
scientia non olet · About LEMON Manuals