LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2008 >> Nitro SLT, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Sensor-Engine Coolant Temperature >> Installation >> 2.8L Diesel

2.8L Diesel

Fig 1: Cylinder Head Assembly
GC0025179Courtesy of CHRYSLER LLC
1 - CYLINDER HEAD BOLT
2 - GLOW PLUG
3 - COOLANT FITTING
4 - CYLINDER HEAD ALIGNMENT DOWEL
5 - GLOW PLUG HARNESS
6 - CYLINDER LINER
7 - CYLINDER BLOCK
8 - CYLINDER HEAD GASKET
9 - CYLINDER HEAD
10 - ROCKER ARM ASSEMBLIES
  1. Install coolant temperature sensor in thermostat housing.
  2. Connect coolant temperature sensor electrical connector.
  3. Refill cooling system. See STANDARD PROCEDURE .
  4. Connect negative battery cable.
scientia non olet · About LEMON Manuals