Fuel Tank
Courtesy of CHRYSLER LLC
- Release fuel system pressure. See STANDARD PROCEDURE .
- Raise and support vehicle.
- Except FFV Fuel Systems:
Drain fuel tank. This is done by removing clamp (9) and hose (7) from fuel tank fill fitting at rear of tank. Position a draining hose from an approved gasoline draining station into the open fuel tank fill fitting.
- Disconnect electrical connector from ESIM switch (4).
- Disconnect quick-connect fittings at front of fuel tank.
- Disconnect quick-connect fitting (8) at rear of fuel tank.
- Support tank with a hydraulic jack.
Courtesy of CHRYSLER LLC
- Remove two fuel tank strap bolts (2) and remove both tank support straps (3).
Courtesy of CHRYSLER LLC
- Carefully lower tank a few inches and disconnect fuel pump module electrical connector (5) at top of tank. To disconnect electrical connector: Push upward on red colored tab to unlock. Push on black colored tab while removing connector.
- Disconnect fuel line (6) at fuel pump module fitting by pressing on tabs at side of quick-connect fitting.
- Disconnect remaining lines from tank.
- Continue to lower tank for removal.
- If fuel tank is to be replaced, remove fuel pump module from tank. See REMOVAL .