LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2007 >> Durango 3.7 K >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Column >> Key/Lock Cylinder >> Removal >> Key Cylinder Housing

Key Cylinder Housing

Fig 1: Locating Steering Column Opening Cover
GC0010460Courtesy of CHRYSLER LLC
  1. Disconnect negative cable from battery.
  2. Remove the steering column opening cover. Refer to REMOVAL .
    Fig 2: Upper & Lower Shrouds
    GC0010461Courtesy of CHRYSLER LLC
  3. Remove the tilt lever handle.
  4. Remove the lower shroud (2) from steering column.
  5. Place shifter in PARK position.
    Fig 3: Removing Key Cylinder
    GC0010462Courtesy of CHRYSLER LLC

    The ignition key (2) must be in the key cylinder (1) for cylinder removal.

  6. A retaining pin is located at side of key cylinder assembly.
    • Rotate key (2) to RUN position.
    • Press in on retaining pin with a small punch (3) , while pulling key cylinder (1) from ignition switch.
    Fig 4: Installing Key Cylinder With Key In Cylinder
    GC0010463Courtesy of CHRYSLER LLC
  7. Remove the key (2) and key cylinder (1) from the column (3).
scientia non olet · About LEMON Manuals