LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2007 >> Caliber SXT, 1.8 C >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Sensor-Impact >> Removal >> Sensor-C-Pillar Side Impact

Sensor-C-Pillar Side Impact

Fig 1: C-PILLAR SIDE IMPACT SENSOR
GC0053697Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  2. Remove the rear quarter panel trim. Refer to REMOVAL .
  3. Remove the screw (4) that secures the side impact sensor (3) to the C-pillar (1).
  4. Disconnect the harness connector (2) from the sensor (3).
  5. Remove the sensor from the C-pillar.
scientia non olet · About LEMON Manuals