LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2007 >> Caliber R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (1.8L Engine (Service Information)) >> Engine Mounting >> Mount-Rear >> Installation

Engine Mounting: Mount-Rear: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: REAR MOUNT-ATX
GC0057320Courtesy of CHRYSLER LLC
  1. Position rear mount (3).
  2. Install rear mount retaining bolts (4) and torque to 50 N.m (37 ft. lbs.).
  3. Install rear mount through bolt (1) and torque to 47 N.m (35 ft. lbs.).
  4. Install oxygen sensor connector (2) retainer to mount (3).
scientia non olet · About LEMON Manuals