LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2006 >> Sprinter 2500, Van Cargo >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Injection >> Fuel Pressure Sensor >> Installation

Fuel Pressure Sensor: Installation

  1. (Refer to (Refer to FUEL SYSTEM - WARNING)  ) Install the sealing ring on to the sensor. See Figure.
  2. Screw the sensor in to the fuel rail. Counter-hold the threaded connection and tighten the sensor to 18 lbs. ft. (25 N.m.). See Figure.
  3. Connect the wiring harness to the sensor.
  4. Install the mixing housing.
    CAUTION: Care must be taken when installing the engine cover. Assure the proper routing of the fuel injector return fuel hose to the banjo bolt fitting in the left rear corner of the cover. Failure to do so may pinch or damage the hose causing fuel leakage or a driveability concern.
  5. Connect negative battery cable.
scientia non olet · About LEMON Manuals