Power Liftgate Control Module: Installation

Fig 1: Locating Power Liftgate Control Module

Courtesy of DAIMLERCHRYSLER CORP.

1. Position the power liftgate control module (4) into the vehicle.
2. Insert the mounting tab into the locating slot (3) on the quarter panel.
3. Tilt the top of the module (4) toward the quarter panel and firmly press the clip (1) into the retaining hole on the quarter panel.
4. Connect the wire harness connectors (2) to the power liftgate control module (4).
5. Install the left quarter trim panel, (Refer to BODY/INTERIOR/QUARTER PANEL TRIM - INSTALLATION) .
6. Connect the battery negative cable.
7. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
8. Perform the power liftgate learn cycle, (Refer to ELECTRICAL/POWER DOORS - STANDARD PROCEDURE - POWER LIFTGATE LEARN CYCLE) .
9. Verify power liftgate system operation.