Module-Compass Temperature: Installation

NOTE: If a new compass mini-trip computer has been installed, the compass will have to be calibrated and the variance set. Refer to COMPASS DEMAGNETIZING  and COMPASS CALIBRATION  for the procedures.

Fig 1: Removing/Installing Computer Module Screws

Courtesy of DAIMLERCHRYSLER CORP.

1. Position the compass mini-trip computer module (1) onto the overhead console housing (2).
2. Reconnect the overhead console wire harness connector to the compass mini-trip computer module connector receptacle.
3. Install and tighten the screws that secure the compass mini-trip computer module to the overhead console housing. Tighten the screws to 2.2 N.m (20 in. lbs.).
   Fig 2: Identifying Overhead Console Connectors

   Courtesy of DAIMLERCHRYSLER CORP.
4. Install the overhead console (4) onto the headliner (Refer to ELECTRICAL/OVERHEAD CONSOLE - INSTALLATION) .
5. Reconnect the negative battery cable.