LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2005 >> Viper >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Driver Airbag >> Installation

Driver Airbag: Installation

  1. Connect horn and airbag wiring connectors to the airbag. Make airbag connection by pressing straight in on the connector. The connector should be fully seated to assure positive connection. Check that the wires are not pinched between airbag and steering wheel during installation.
  2. Install the airbag screws and torque to 7 to 9 N.m (65 to 85 in. lbs.).
    WARNING: DO NOT CONNECT BATTERY NEGATIVE CABLE (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM) .
  3. Place battery access cover into place and install four bolts.
  4. Close deck lid.
  5. Verify vehicle and system operation.
scientia non olet · About LEMON Manuals