LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2005 >> Caravan Base, 3.3 E >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Liftgate System >> Pinch Sensor >> Removal

Pinch Sensor: Removal

  1. Disconnect and isolate the battery negative cable.
  2. Remove trim panel from liftgate, (Refer to BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/TRIM PANEL - REMOVAL) .
  3. Disconnect the pinch sensor wire harness connector. See Fig 1.
    Fig 1: Pinch Sensor Location
    GC0024783Courtesy of DAIMLERCHRYSLER CORP.
    1 - LIFTGATE
    2 - PINCH SENSOR ASSEMBLY
    3 - LIFTGATE PROP ROD
    4 - PINCH SENSOR WIRE HARNESS CONNECTOR
    5 - PINCH SENSOR WIRE HARNESS
  4. Remove screws holding the pinch sensor to liftgate.
  5. Feed the pinch sensor wire harness out of the liftgate and remove the sensor from the vehicle.
scientia non olet · About LEMON Manuals