LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2005 >> Caravan Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Ignition Control System >> Camshaft Position Sensor >> Removal >> Removal - 3.3/3.8L

Removal - 3.3/3.8L

  1. Disconnect the negative battery cable.
  2. Remove the air box cover and inlet tube. See Fig 1.
    Fig 1: Air Box Cover
    GC0024468Courtesy of DAIMLERCHRYSLER CORP.
  3. Disconnect camshaft position sensor electrical connector from the wiring harness connector. See Fig 2.
    Fig 2: Camshaft Position Sensor - 3.3L/3.8L
    GC0024730Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove bolt holding sensor.
  5. Rotate sensor away from block.
  6. Pull sensor up out of the chain case cover. Do not pull on the sensor wiring.  There is an O-ring on the body of the sensor. The O-ring may make removal difficult. A light tap to top of sensor prior to removal may reduce force needed for removal.
scientia non olet · About LEMON Manuals