LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2004 >> SRT-4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Exterior) >> Front Fender >> Installation

Front Fender: Installation

WARNING: This page is about a different car, the 2003 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place fender in position on vehicle (Fig. Figure ).
  2. Start the center upper rail bolt.
  3. From inside engine compartment, install all the bolts attaching fender to upper rail and tighten.
  4. Install lower cowl panel bolt to fender.
  5. Install rocker panel bolt to fender.
  6. Place fascia into position.
  7. Install fender to fascia nuts.
  8. Install inner splash shield.
  9. Install right side pulley splash shield.
  10. Install headlamp assembly.
  11. Check fender for flush and gap.
scientia non olet · About LEMON Manuals