Front Wiper Switch: Removal

WARNING: This page is about a different car, the 2003 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

To service the front wiper/washer switch, the multi-function switch must first be removed.

Open hood.
Disconnect and isolate the battery negative cable (Figure ).
Remove both upper and lower steering column shrouds (Refer to STEERING/COLUMN/UPPER SHROUD - REMOVAL ).
Disconnect both posi-lock harness connectors at the rear of the multi-function switch (Fig 1 ).

Fig 1: Removing/Installing Multi-Function Switch
Courtesy of DAIMLERCHRYSLER CORP.
Remove multi-function switch mounting screws (Fig 1 ) and remove switch from vehicle.
Remove the two torx screws retaining the wiper/washer switch to the multi-function switch and separate (Fig 2 ).

Fig 2: Removing/Installing Front Wiper Switch
Courtesy of DAIMLERCHRYSLER CORP.