LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2004 >> Neon SXT, Automatic >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Injection >> Throttle Position Sensor >> Installation >> Installation - 2.4L SRT-4

Installation - 2.4L SRT-4

  1. The throttle shaft end of the throttle body slides into a socket in the TPS. The socket has two tabs inside it. The throttle shaft rests against the tabs. When indexed correctly, the TPS can rotate clockwise a few degrees to line up the mounting screw holes with the screw holes in the throttle body. The TPS has slight tension when rotated into position. If it is difficult to rotate the TPS into position, install the sensor with the throttle shaft on the other side of the tabs in the socket. Tighten mounting screws to 5.1 N.m (45 in. lbs.) torque.
  2. After installing the TPS, the throttle plate should be closed. If the throttle plate is open, install the sensor on the other side of the tabs in the socket.
  3. Connect the electrical connector and lock connector.
  4. Relocate the air cleaner box and install the 2 fasteners.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals