LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Viper >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering Pump >> Pump >> Installation

Power Steering Pump: Pump: Installation

  1. Install power steering pump in reverse order of removal.
  2. Install three power steering pump mounting bolts (Figure). Tighten mounting bolts to 23 N.m (200 in. lbs.) torque.
  3. Install fluid cooler return hose on fitting of power steering pump reservoir. Install hose clamp on return hose past upset bead on power steering reservoir fitting.
  4. Install radiator fan motor return hose on fitting of power steering pump reservoir. Install hose clamp on return hose past upset bead on power steering reservoir fitting.
  5. Install power steering pressure hose in power steering pump pressure fitting. Tighten pressure hose tube nut to a torque of 28 N.m (21 ft. lbs.) torque.
  6. Connect A/C clutch coil wire connector.
  7. Install accessory drive belt. (Refer to - DRIVE BELTS - INSTALLATION ).
  8. Install air cleaner. (Refer to - AIR INTAKE SYSTEM - INSTALLATION ).
  9. Connect the battery negative (-) cable to battery negative battery terminal.
    10. CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar(R) Power Steering Fluid or equivalent.
  10. Fill power steering pump reservoir to correct fluid level. (Refer to STANDARD PROCEDURE )
  11. Perform Power Steering Pump Initial Operation procedure. (Refer to STANDARD PROCEDURE - POWER STEERING PUMP INITIAL OPERATION ).
  12. Check for leaks at all hose connections.
scientia non olet · About LEMON Manuals