Ignition Keys

1. Turn the ignition switch to the ON position (transmission in Park/Neutral).
2. Use the DRBIII® and select THEFT ALARM, SKIM, then MISCELLANEOUS.
3. Select PROGRAM IGNITION KEY's.
4. Enter secured access mode by entering the vehicle 4-digit PIN.
NOTE: A maximum of 8 keys can be learned to each SKIM. Once a key is learned to a SKIM it (the key) cannot be transferred to another vehicle.
5. Obtain ignition keys to be programmed from the customer (8 keys maximum).
6. Using the DRBIII®, erase all ignition keys by selecting MISCELLANEOUS, and ERASE ALL CURRENT IGN. KEYS.
7. Program all of the ignition keys.

If ignition key programming is unsuccessful, the DRBIII® will display one of the following messages:

• Programming Not Attempted
  
  The DRBIII® attempts to read the programmed key status and there are no keys programmed into SKIM memory.
• Programming Key Failed (Possible Used Key From Wrong Vehicle)
  
  SKIM is unable to program an ignition key transponder due to one of the following:
  1. The ignition key transponder is faulty.
  2. The ignition key transponder is or has already been programmed to another vehicle.
• 8 Keys Already Learned, Programming Not Done
  
  The SKIM transponder ID memory is full.
• Learned Key In Ignition
  
  The ID for the ignition key transponder currently in the ignition lock cylinder is already programmed in SKIM memory.