Generator Cartridge Fuse: Installation

If a generator cartridge fuse fails, be certain to inspect and test the vehicle charging system before replacing the cartridge fuse and returning the vehicle to service. Refer to GENERATORS & REGULATORS for the charging system diagnostic procedures.

1. Position the generator cartridge fuse onto the two B(+) terminal stud bus bars within the PDC.
2. Install and tighten the two screws that secure the generator cartridge fuse to the two B(+) terminal stud bus bars within the PDC. Tighten the screws to 3.4 N.m (30 in. lbs.). Be certain that both screws are tightened to the proper torque value. 
3. Install and latch the cover onto the PDC.
4. Reconnect the battery negative cable.