Power Mirror Switch
Power mirror switches are located in the Driver Door Module (DDM). Remove DDM. See DRIVER DOOR MODULE under REMOVAL & INSTALLATION. Disconnect DDM C2 harness connector. Check continuity between power mirror switch terminals (component side) with mirror selector and position switch in appropriate position. See POWER MIRROR SWITCH CONTINUITY TEST table. See Figure . If continuity is not as specified, replace switch.
POWER MIRROR SWITCH CONTINUITY TEST
| Mirror Selector Position | Continuity Between Terminals No. | |
|---|---|---|
| "L" (Left) | ||
| Up | 1 & 3 | |
| Down | 2 & 3 | |
| Left | 3 & 6 | |
| Right | 2 & 3 | |
| "R" (Right) | ||
| Up | 3 & 7 | |
| Down | 2 & 3 | |
| Left | 3 & 4 | |
| Right | 2 & 3 | |