LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Durango Base, 5.9 Z, 4WD, Part Time >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling >> Engine Block Heater - 5.9L >> Installation

Engine Block Heater - 5.9L: Installation

  1. Clean and inspect the block heater hole.
  2. Install new O-ring seal(s) to heater in gasoline engines.
  3. Insert block heater into cylinder block.
  4. With heater fully seated, tighten center screw to 2 N.m (17 in. lbs.).
  5. Fill cooling system with recommended coolant. (Refer to STANDARD PROCEDURE - REFILLING COOLING SYSTEM 5.9L ENGINE ).
  6. Start and warm the engine.
  7. Check block heater for leaks.
scientia non olet · About LEMON Manuals