LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1998 >> Intrepid Base, 3.2 J >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Body Control Tests >> OTIS Test 5A - Repairing OTIS Switches

OTIS Test 5A - Repairing OTIS Switches

NOTE: Perform OTIS TEST 1A  before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . Perform, after each repair, VERIFICATION TEST VER-1A - BODY VERIFICATION TEST  . Drive vehicle at least 3 miles (greater than 25 MPH) to update OTIS and perform, after each repair, VERIFICATION TEST VER-1A - BODY VERIFICATION TEST  .
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Turn ignition off and leave key in ignition. Open driver's door. If chime sounds, go to next step. If chime does not sound, go to CHIME TEST 5A.
  2. Turn ignition on and close driver's door. Press each button on OTIS unit and listen for audible beep at Body Control Module (BCM). If beep was heard each time a button is pressed, OTIS is currently operating correctly. If beep was not heard each time a button was pressed, replace OTIS unit.
scientia non olet · About LEMON Manuals