LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1998 >> Intrepid Base, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Body Control Computer) >> Self-Diagnostic System >> Test 104F - Wiper Switch Power Supply

Test 104F - Wiper Switch Power Supply

WARNING: This page is about a different car, the 1996 Eagle Vision, 1996 Dodge Intrepid, 1996 Chrysler New Yorker, 1996 Chrysler LHS, and 1996 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER  section in this article. Perform TEST VER-1  VERIFICATION TEST after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Remove and inspect fuse No. 10 in the junction block. See Figure . Junction block is located behind end cover, on left side of instrument panel. If fuse is blown, go to TEST 104G. If fuse is not blown, go to next step.
  2. Using scan tool in voltmeter mode, check voltage on fuse No. 10 (Black/White wire). If voltage is more than 10 volts, repair open Dark Blue wire. If voltage is 10 volts or less, repair open Black/White wire.
scientia non olet · About LEMON Manuals