Speed (Cruise) Control Switch
WARNING: This page is about a different car, the 1997 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Wait 2 minutes for air bag system capacitor to discharge. Remove speed control switch assembly from steering wheel and disconnect connector. See SPEED (CRUISE) CONTROL SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance at speed control switch terminals No. 1 and 2. See Fig 1 Resistance should be 798-814 ohms with no switched depressed. Check resistance at speed control switch terminals No. 2 and 3. If continuity is not as specified in SPEED CONTROL SWITCH RESISTANCE table, replace defective speed control switch.
SPEED CONTROL SWITCH RESISTANCE
| Switch Position | Resistance (Ohms) | ||
|---|---|---|---|
| None Depressed | (1) Infinity | ||
| ON | 900-918 | ||
| RESUME/ACCEL | 15,246-15,554 | ||
| SET/DECEL | 6584-6716 | ||
|
|||