LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1998 >> Durango 5.2 Y, Part Time >> Repair and Diagnosis >> Steering >> Power Steering System - Recirculating Ball >> Overhaul >> Spool Valve >> Assembly

Spool Valve: Assembly

NOTE: Clean and dry all components, then lubricate with power steering fluid.
  1. Install spool valve spool O-ring.
  2. Install spool valve in valve body by pushing and rotating. The hole in the spool valve for stub shaft pin must be accessible from opposite end of valve body.
  3. Install stub shaft in valve spool and engage locating pin on stub shaft into spool valve hole.
    4. NOTE: Notch in stub shaft cap must fully engage valve body pin and seat against valve body shoulder.
  4. Install O-rings and teflon rings over the O-rings on valve body.
  5. Install O-ring into the back of the stub shaft cap.
  6. Install stub shaft and valve assembly in the housing. Line up worm shaft to slots in the valve assembly.
  7. Install thrust support assembly.
    8. NOTE: The thrust support is serviced as an assembly. If any component of the thrust support is damaged the assembly must be replaced.
  8. Install adjuster nut and lock nut.
  9. Adjust thrust bearing preload and over-center rotating torque.
scientia non olet · About LEMON Manuals