LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1997 >> Caravan Base, 3.3 R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Controls - Remove/Install/Overhaul - 3.0L) >> Ignition System >> Distributor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect electrical connector at side of distributor. Remove distributor cap. Rotate engine until rotor points toward intake manifold.
  2. Place reference mark on distributor and intake manifold at rotor location for installation reference. Remove distributor hold-down nut. Remove distributor with "O" ring from engine.
  3. To install, reverse removal procedure. Use NEW "O" ring if necessary. Ensure "O" ring is properly seated on distributor. Ensure rotor and distributor align with reference mark on intake manifold when installing distributor. Tighten distributor hold-down nut to specification. See TORQUE SPECIFICATIONS. If necessary to check firing order, see SPECIFICATIONS - 3.0L article.
scientia non olet · About LEMON Manuals