Crankshaft Position Sensor: Removal
WARNING: This page is about a different variant/trim than selected.
- Crankshaft position sensor is located on cylinder block, behind generator, near oil filter.
- Raise and support vehicle. Disconnect electrical connector at crankshaft position sensor. Remove retaining bolt and crankshaft position sensor.
CAUTION:
If crankshaft position sensor is reused, old paper spacer must be removed from crankshaft end of crankshaft position sensor and a NEW paper spacer installed before installing crankshaft position sensor. If using a NEW crankshaft position sensor, ensure paper spacer is installed on crankshaft end of crankshaft position sensor.