LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1997 >> Caravan Base, 3.3 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Keyless Entry System - Remote) >> Transmitter Programming >> Keyless Entry System - Remote >> Programming Procedure (RWD Vans)

Programming Procedure (RWD Vans)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1996 Plymouth Voyager, 1996 Plymouth Grand Voyager, 1996 Dodge Ram Wagon, 1996 Dodge Ram Van, and 1996 Dodge Grand Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate Dark Green program enable wire under left side of instrument panel. Wire is taped to back of harness left of steering column, near floor. End of enable wire has black rubber cap.
  2. Connect program enable wire to ground. Turn ignition on. Power door locks will cycle. Depress either button on transmitter. Doors locks will cycle to confirm signal was received. Depress either button on second transmitter if needed. Doors locks will again cycle to confirm signal was received.
  3. Disconnect enable from ground. Secure wire to harness. Turn ignition off. Verify transmitter(s) operation.
scientia non olet · About LEMON Manuals