Diagnostic Procedure
NOTE:
Battery must be fully charged.
- Attempt to start engine. Crank for up to 10 seconds, if necessary.
- Connect the DRB scan tool (or equivalent aftermarket scan tool) to the engine diagnostic connector. Diagnostic connector is located under left side of dash, on left kick panel.
- If DRB screen displays "No Response," go to NS-6A: REPAIRING A "NO RESPONSE" CONDITION .
- If the DRB screen is blank or has a DRB message, go to DRB SCAN TOOL PROBLEMS .
- If trouble code messages are displayed, go to DIAGNOSTIC TROUBLE CODE DEFINITIONS .
- If there are no trouble codes displayed, go to one of the following.
- For driveability problems, go to NTC-1A: NO TROUBLE CODE TEST MENU .
- For no start and start stall problems, go to NS-SEL: NO START SELECTION MENU .