LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1996 >> Intrepid Base, 3.3 T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - Adjustments - 3.5L) >> Throttle Position Sensor

Throttle Position Sensor

WARNING: This page is about a different variant/trim than selected.
NOTE: Throttle Position (TP) sensor is non-adjustable. Use following procedure to check TP sensor calibration. For complete testing of TP sensor and wiring circuit, refer to the appropriate TESTS W/CODES article.
  1. Remove components for access to electrical connector at TP sensor, mounted on throttle body. With electrical connector installed on TP sensor, turn ignition on with engine off. DO NOT  start engine.
  2. Using Digital Volt-Ohmmeter (DVOM), measure voltage at center terminal on electrical connector for TP sensor with throttle valve closed (idle position). Voltage should be greater than .6 volt.
  3. Slowly open throttle to full throttle and note voltage reading. Voltage should smoothly increase to less than 4.5 volts. Replace TP sensor if voltage is not within specification.
scientia non olet · About LEMON Manuals