Test TC-15B - Speed Control Solenoid Circuits

NOTE: Perform TEST TC-15A before proceeding.

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY . For wiring diagram, see WIRING DIAGRAMS - 2.4L article.

Using external ohmmeter, check resistance between brake switch connector terminal No. 4 (Dark Blue/Red wire) and terminal No. 3 (Dark Blue/Red wire) on connector for speed control servo.
If resistance is less than 5 ohms, replace brake switch. Perform TEST VER-4A. If resistance is 5 ohms or more, repair open circuit in Dark Blue/Red wire. Perform TEST VER-4A.