LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1994 >> Dakota WS, 2.5 G >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - Basic Testing - 5.2L) >> Fuel System >> Fuel Pressure >> Fuel Pump Pressure Test

Fuel Pump Pressure Test

WARNING: This page is about a different variant/trim than selected.
  1. Begin basic diagnosis of fuel system by determining fuel system pressure. Release fuel pressure. See FUEL PRESSURE RELEASE.
  2. Remove fuel rail test port protective cap. Connect Fuel Pressure Gauge (C-4799) to fuel rail test port. Test port is located at rear of engine. Start engine and allow to idle. If pressure is more than 45 psi (310 kPa), fuel pump is okay. Replace fuel filter/fuel pressure regulator assembly located on top of fuel pump module. If pressure is zero psi, use DRB diagnostics. Proceed to article in the ENGINE PERFORMANCE section.
FUEL PUMP REGULATED PRESSURE(1)

Application Pressure - psi (kPa)
5.2L 35-45 (241-310)
(1) Fuel pressure taken at engine idle (no load).
scientia non olet · About LEMON Manuals