LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1994 >> Dakota WS, 2.5 G >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.5L TBI >> Self-Diagnostic Tests >> Test NTC-7B - Checking Oxygen (O2) Sensor Switching

Test NTC-7B - Checking Oxygen (O2) Sensor Switching

NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION  in this article. For wiring diagrams, see WIRING DIAGRAMS  section.
  1. Allow engine to idle. Inspect engine for vacuum leaks. Repair vacuum leaks as necessary. Perform TEST VER-2  . If no vacuum leaks exist, read O2 sensor signal voltage using DRB.
  2. If voltage is more than 0.1 volt, go to step 4). If voltage is less than 0.1 volt, turn ignition off. Disconnect O2 sensor connector. Disconnect Powertrain Control Module (PCM) connector. Using DRB in ohmmeter mode, check resistance of O2 sensor connector Black/Dark Green wire.
  3. If resistance is less than 10 ohms, repair short to ground in Black/Dark Green wire. Perform TEST VER-2. If resistance is more than 10 ohms, replace O2 sensor. Perform TEST VER-2.
  4. Turn engine off. Replace O2 sensor. Turn ignition on. Using DRB, reset adaptive fuel memory. Start engine. Allow engine to reach normal operating temperature.
  5. Using DRB, read O2 sensor state. If O2 sensor state is switching, repair is complete. Perform TEST VER-2. If O2 sensor state is not switching, go to TEST NTC-15A  .
scientia non olet · About LEMON Manuals