Switch Test
Remove power seat position switch from its mounting. Using an ohmmeter, perform continuity check between pins with switch set in specified position. See POWER SEAT SWITCH CONTINUITY CHECK . If there is no continuity at any of the switch positions, replace switch.
POWER SEAT SWITCH CONTINUITY CHECK
| Switch Position | Check Continuity Between |
|---|---|
| OFF | Pins B & N; Pins B & J |
| Pins B & M; Pins B & E | |
| Pins B & L; Pins B & K | |
| VERTICAL UP | Pins A & E; Pins A & M |
| Pins B & N; Pins B & J | |
| VERTICAL DOWN | Pins A & J; Pins A & N |
| Pins B & M; Pins B & E | |
| HORIZONTAL FORWARD | Pins A & L; Pins B & K |
| HORIZONTAL AFT | Pins A & K; Pins B & L |
| FRONT TILT UP | Pins A & M; Pins B & N |
| FRONT TILT DOWN | Pins A & N; Pins B & M |
| REAR TILT UP | Pins A & E; Pins B & J |
| REAR TILT DOWN | Pins A & J; Pins B & E |